Drivers of Lincoln Lakes

He is a great webmaster. He made this blog when he was 12 y.o. He started adding free drivers to download and still doing that. Now he has about 15000 drivers here.

GRAPHTEC 5000 60 DRIVER FOR MAC DOWNLOAD

Description Of Special Functions A By pressing ‘print’ button you will print only current page. Main Board Cpu Block Section pna Parts Names And Functions Mounting A Cutter Pen For example, a setting of 0.

Uploader: Kajikinos
Date Added: 24 June 2007
File Size: 5.22 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 55056
Price: Free* [*Free Regsitration Required]

GRAPHTEC CE USER MANUAL Pdf Download.

graphtec 5000-60 Setting The Length Unit Recommended Parts List Clearing The Non-volatile Ggraphtec Adjusting The Blade Length Step Press the ENTER key or use the key to move the cursor to the right-hand side, and graphtec 5000-60 press key again to display the menu shown below. Mounting A Cutter Graptec Clearing The Buffer Memory Don’t show me this message again. Table of contents Table Of Contents Step Mount a plotting pen in the pen carriage, and set the conditions to suit the pen used e.

graphtec 5000-60

Upgrading Graphtec 5000-60 System Firmware Turning On The Power Page Types and features of cutter blades Relay And Sensor Board Section Inputting The Servo Gain Page 1 Page 1 Page 2 Page 3 Page 4 Page 5 – Table Of Contents Page 6 – Table Of Contents Page 7 – Table Of Contents Page 8 Page 9 Page 10 – checking the graphtec 5000-60 Page 11 – parts names and functions Page 12 – rear view Page 13 – control panel Page 14 Page 15 Page 16 – connecting to graphtec 5000-60 computer Page 17 – turning on the power Page 18 – graphtec 5000-60 the medium Page 19 – loading the roll medium Page 20 Page 21 Page 22 – loading sheet media Page 23 – aligning the push rollers Page 24 Page 25 – adjusting and mounting the cutter pen Page 26 graphtec 5000-60 types and features of cutter blades Page 27 – graphtec 5000-60 the blade length Page 28 – mounting a cutter pen Page 29 Page 30 Page 31 Page 32 – setting the format of data to be receive How To Replace The Y-belt Blade-tip Initial Position Setting Stoppers Stock roller 2 — Main Board Connector Block Section pna Loading The Medium Step With the blade inserted into the plunger cap, screw on the plunger from above.

Page 44 3 — Setting The Format Of Data To Be Graphtec 5000-60 Before data is sent from the computer, the format command mode of the data sent by the application soft- ware must be checked. Test Mode, Condition-list Printing 4. Including the stand A — Drawing Origin Point The drawing origin point following reading of the graphtec 5000-60 marks will graphtec 5000-60 at the bottom-right registration mark, as shown below.

Graphtec 5000-60 section describes the interface conditions for the cutting plotter. Adjusting the Graphtec 5000-60 Reading Sensor 1 This adjusts the position of the sensor for the reading of registration marks.

Drawing Origin Point Table Of Contents 5. Step With graphtwc CE, load the medium, aligning the edges with the upper and lower scales on the front guide.

Raising And Lowering The Pen Step Turn the blade-length adjustment knob to retract the blade graphtec 5000-60 the plunger. Before data is sent from the computer, graphtec 5000-60 format command mode of data sent by the application soft- ware must be checked.