Fabric weight standard test method for Mass Per Unit Area (weight) of fabric using ASTM Test Method D The ASTM D Basis weight test method covers four methods for the measurement of fabric mass per unit area (weight). It is applicable to most fabrics. ASTM D Standard Test Method for Mass Per Unit Area (Weight) of Fabric1 – Download as PDF File .pdf), Text File .txt) or read online. ASTM D
|Published (Last):||5 January 2012|
|PDF File Size:||10.13 Mb|
|ePub File Size:||20.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
The second option is Option B which is applicable to a full-width sample cut from a full piece, roll, bolt, or cut. Combining values from the two systems may result in non-conformance with the standard.
ASTM D 3776 Basis Weight
This abstract is a brief summary of the referenced standard. These test methods cover the measurement of fabric mass per unit area weight atsm is applicable to most astm d 3776. Measurements by this method do not include selvages and should be reported as such, unless a selvage allowance is specified.
Work Item s – proposed revisions of this standard. The results are considered to be applicable to the sample only and astm d 3776 necessarily to the lot from which the sample was taken.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ASTM does not give any warranty astm d 3776 or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Fabric Weight Testing using ASTM Test Method D
Referenced Documents purchase separately Astm d 3776 documents listed below are referenced within the subject standard but are not provided as part of the standard.
Link to Active Zstm link will always route to the current Active version of the standard.
It is informational only and not an official part 37766 the standard; the full text of the standard itself must be referred to for its use and application. The values stated in each system may not be astm d 3776 equivalents; therefore, each system shall be used independently of the other. Historical Version s – view previous versions of standard.
Option A may astm d 3776 used for acceptance testing of commercial shipments since it has been used extensively in the trade. Option C on the other hand is applicable when a small swatch of fabric is sent to the laboratory to be used as the test specimen. Astm d 3776 last option is Option D which is intended for use with narrow fabrics as so designated by the trade.
Unless otherwise specified, these results 376 include selvages aetm will be on the basis of conditioned fabric.
There are four approved options in the measurement of fabric mass per unit area: